ASX-listed Frontier Energy has started major construction on Stage One of its Waroona Renewable Energy Project, about 120 km south of Perth in Western Australia. The first stage pairs a 132 MW solar facility with an 81.5 MW/6.9-hour DC-coupled battery, connecting to the South West Interconnected System via the 330 kV Landwehr Terminal, with first generation scheduled for 2028. The company says it will be the largest solar and battery hybrid on the SWIS and replace a third of the output of the Collie coal plant, due to close in 2027.
Australia's Clean Energy Regulator (CER) rated 61.19% of home batteries and 23.11% of solar systems inspected under the Small-scale Renewable Energy Scheme in 2025–26 as substandard. It completed a record 6,554 inspections, 3,425 of them battery systems. One account puts unsafe installs at 0.93% for solar and 0.95% for batteries, while another says up to 2% were deemed unsafe. Faults stem mostly from poor workmanship, and the CER is launching a targeted response on installer compliance.
Central Queensland Power, a joint venture of Energy Estate and the Australian arm of RES, has launched an expressions of interest process through Gateway by ICN for its proposed Wooderson solar and battery project at Mount Alma, about 40 km southwest of Gladstone in Queensland. The project pairs a 450 MW solar facility with a 450 MW DC-coupled battery system offering up to 3,600 MWh of storage. The developer seeks about 980,000 solar panels, a substation, switching yard and a 275 kV transmission connection, with lead contractor procurement expected later this year.
Researchers at UNSW Sydney have built a prototype battery health test that they say is 95.5% faster and more than 80% cheaper than existing methods. The platform sends short electrical pulses through each cell and uses statistical models to estimate health in under three minutes per cell, with lab tests showing more than 90% accuracy across LFP, NCA and NMC chemistries. Current testing uses a roughly 10-hour charge-discharge cycle costing about AUD 120 ($85) per EV pack, while the team targets under AUD 25. The approach is meant to boost second-life battery use and keep waste out of landfill.
The Australian government cancelled procurement of an administrator for its National Solar Panel Recycling Pilot on 10 November without awarding a contract, citing undisclosed changes to the industry since the April 2026 tender. The cancellation came the same day a six-month suspension, triggered by a procurement complaint and investigation, was lifted. The AUD 24.7 million ($16.9 million) pilot would have arranged collection of up to 250,000 decommissioned panels from around 100 sites. The government says it is considering next steps.
The Bendemeer Solar Farm and battery project near Tamworth in NSW's New England region, developed by Singapore-based Metis Energy through subsidiary Athena Energy, has been referred to the state's Independent Planning Commission. The project drew 119 objections, 19 above the new 100-objection threshold that triggers Commission review, although the Department of Planning, Housing and Infrastructure found it approvable subject to conditions. It comprises a 200 MW solar farm and a 150 MW / 300 MWh battery, and is part of a proposed hub that could add a separately assessed 360 MW wind farm.
Australian battery developer Li-S Energy has sold its 10 Ah lithium-sulphur Power Cells to SOFWERX, a US innovation hub that fast-tracks technology into US Special Operations Command, for evaluation against military requirements. SOFWERX will assess the Australian-made cells for air, land and sea uses including drones, robotics and uncrewed maritime platforms, where battery weight and endurance matter most. Brisbane-based Li-S, which manufactures in Geelong, Victoria, calls the sale a major commercialisation milestone.
Longi will supply about 300,000 Hi-MO 9 bifacial modules using its hybrid passivated back-contact cell technology to OX2 for the Muswellbrook solar-plus-storage project in the Upper Hunter region of New South Wales. OX2 is building the $302 million (USD 203 million) project with the Australian arm of Idemitsu, and construction has begun. It pairs a 135 MW (176 MWdc) solar farm with a 100 MW / 200 MWh battery on a 482-hectare site next to the shuttered Muswellbrook coal mine. Longi cites module efficiencies of up to 24.8%.
CATL product solution manager David Santiago presented specifications for the Tener Sodium battery energy storage system in an Oct. 29 ATA Insights webinar, following its June launch at The Smarter E 2026 in Munich with more than 30 MWh per block. The four-hour system is built in pairs of two to eight cabinets; the full block measures 18.2 m by 7 m by 3.5 m, with each cabinet about 4.5 m long, 44 to 45 tonnes and roughly 4 MWh. CATL plans an LFP version using the same cabinets and layout at about 50 MWh.
Huawei has launched the Luterra S2, an all-in-one residential energy storage system that combines a hybrid inverter, LFP batteries and AI-based energy management. Single-phase inverters range from 3 kW to 10 kW and three-phase units from 5 kW to 20 kW, with up to three 20 kW inverters connectable in parallel for 60 kW. Battery modules come in 5.02 kWh and 7.03 kWh nominal capacities, and up to 48 packs can be linked for a maximum of 336 kWh. Huawei rates the batteries for a service life exceeding 15 years.
An international research team including scientists from the University of New South Wales has developed a glass-glass photovoltaic module design and an induction heating-assisted delamination method to make end-of-life panels easier to recycle. Using induction heating, the team separated a test module's layers and recovered 99.8% of its original mass, including glass, the silicon cell and polymer encapsulant. In the fastest test, the layers came apart in five seconds, leaving the cell intact with no visible polymer residue. The researchers used Comsol Multiphysics simulations to study induction heating in PERC cells and heat transfer through module layers.
Chinese solar manufacturer DMEGC has unveiled the Infinity RT 3.0 series, six bifacial glass-glass PV modules built with steel frames instead of aluminum. The zinc-aluminum-magnesium coated steel has nearly twice the tensile strength of conventional aluminum alloys, letting modules withstand snow loads up to 6,000 Pa and wind loads up to 5,000 Pa with suitable mounting. An S-shaped frame cross-section cuts rear-side vertical shading by 76%, raising unshaded rear area by 3.6% for a theoretical bifaciality gain of about 2.8%.
Rural Australian communities hosting large clean energy projects face pressure on farmland, roads, housing and services in exchange for promised investment. In Victoria, ahead of a state election, some councils have been sidelined in key decisions and planning laws changed to fast-track projects, drawing fierce backlash. The Australian Energy Market Operator estimates net zero will require $106 billion (USD 72 billion) in new investment, raising questions about whether regional communities get a meaningful say and benefit.
Data centre operator AirTrunk has signed an exclusivity agreement with European Energy Australia covering more than 1 GW of renewable projects in the Hunter region of New South Wales. The projects include a 260 MW solar farm, an 800 MWh battery system and a 350 MWp wind project in the Hunter-Central Renewable Energy Zone. The companies are discussing a long-term power purchase agreement, with solar and battery operation expected by 2030, to supply AirTrunk's proposed 550 MW Kurri Kurri data centre campus.
Sydney-based Wollemi Capital, with the Rest superannuation fund, acquired a majority stake in Redball Energy in its first US energy investment. Washington-based Redball owns and operates about 4,500 rooftop solar systems in the Mid-Atlantic and New England, providing project financing and asset ownership rather than direct sales. The investment will fund expansion of its installer network and a move into battery storage.
A South Korean research team has developed a model that predicts power output and hot-spot risk in colored building-integrated PV arrays displaying artistic images. The team modeled arrays showing 50 masterpieces, including Vermeer's Girl with a Pearl Earring and van Gogh's Café Terrace at Night. Because each colored cell needs a different reflection profile, photocurrent varies across the array, which can cut output and expose cells to reverse bias under some bypass-diode setups. The method estimates a minimum-loss reflection spectrum per pixel and runs equivalent-circuit simulations of the array.
Alinta Energy, owned by Sembcorp Industries, has been commercially operating its 100 MW/200 MWh Wagerup battery energy storage system in Western Australia since September. The battery sits about 120 km south of Perth beside Alinta's 392 MW gas-fired Wagerup Power Station and supports renewable integration into the South West Interconnected System. Executive Ken Woolley said difficult site conditions required significant redesign, including raising the platform. A second, 300 MW battery was approved for the site in July 2024.
A CSIRO report on lithium-ion battery components names two front-runners for a sovereign Australian battery manufacturing capability. The first is prismatic cell cans made from Australian aluminium by impact extrusion; the second is copper current collector foil produced by electrolytic deposition. The researchers compared the manufacturing requirements with existing domestic capabilities. CSIRO's Adam Best said this could let Australia move beyond exporting raw and refined materials toward higher-value products.
TCL Solar carried out ammonia corrosion resistance testing under the IEC 62716 standard on 625W TOPCon modules supplied to the Gordon Cattle and Solar Farm, a 4.7 MW agrivoltaic dairy project in Galatea, New Zealand. About 700 cattle will graze beneath 2.2-metre Clenergy tracking systems. Ammonia from manure and farm processes can corrode module components near livestock, reducing long-term performance. The owners also expect shade, lower soil temperatures and moisture retention for grazing land.
Sydney electricity distributor Ausgrid has released a digital energy mapping tool supporting its Community Power Network trial, showing where new solar, battery and energy projects would work best based on connection and curtailment data. The tool covers Mascot-Botany, the Northern Central Coast and Caringbah. The trial explores using surplus commercial and industrial rooftop solar to share energy with renters and apartment dwellers who lack solar access.